MS Scaffolding Accessories, Manufacturer, Exporter

It is a round nut with handle used in Prop-Outer enclosed on sleeve for altering the height.

We have two types of prop-nut,

• L&T type (Heavy)
• Normal / Sada type (Light)

It is made from 60mm OD (50 NB) (thickness 3.2mm) pipe of length 200mm almost fully threaded with slot section used in Prop-Outer.

It is also called as Prop-Barrel.

It is used in shuttering work to provide the necessary strength, while building concrete structures like column, beam, retaining wall, etc. Also, called as Tie-bar or Hanger-Rod resembles to a fully threaded rebar.

It is used for locking for tie-rod. There are various types & sizes of tie-rod nut apart from which we usually deal for tie-rod of size 16mm OD only which are,

• Anchor-Nut (2-leg)(dia. 90mm)(Heavy / Light)
• Anchor-Nut (3-leg)(dia. 100mm)(Heavy / Light)
• Wing-Nut (also called as chidiya-nut)

Also called as tie-rod water barrier nut it is widely used in formwork water retaining structures & helps in saving water and prevention of water seepage. There are various types & sizes of water stopper apart from which we usually deal for tie-rod of size 16mm OD only.

Also called as joint-pin it is manufactured from 38mm OD (thickness 2.5mm) pipe of length 250mm with two holes used for interlocking two verticals one above another.

Also called as stub-pin & wedge it is used to fasten two mivan formwork parts.

It is used in formwork process. Generally, two types are available,

• Male / Female Wedge Clip (Standard size : 70mm)
• U-Type Wedge Clip

Also called as gogo-nut it is used for holding column, beam, retaining wall, etc. in alignment and avoid the bulging of the same. There are various types & sizes of gogo-nut apart from which we usually deal for tie-rod of size 16mm OD only.

Manufactured from flat of 6mm with dimensions 150 x 150 mm having center hole & four corner holes. Generally used at bottom of Prop Outer or Base Jack.

Manufactured from angle (65 x 65 x 6 mm) of length 130mm having three corner holes on one side. Generally used at top of Prop Inner.

It is a round nut used in Screw-Jack for altering the height.

Consists of one tyre, rim & hub each (either seperately provided if needed) for wheelbarrow.

Comprises of top-cup, bottom-cup & ledger-blade used in Cuplock standard & ledger.

Manufactured from flat of 6mm with dimensions 75 x 75 x 110 mm having one hole on one side each used in U-Jack.

Through the help of scaffolding castors, creation of commercially available scaffolds mobile is possible. The castors are inserted into the static scaffold tube and make it mobile and safe simultaneously, that will make all work on a wide variety of construction projects in the vertical plane and rough floors. The working person will be able to move the scaffolding without any problems.

It is widely used in several on-site construction buildings for the purpose of mixing concrete.

Standardly manufactured from 12 guage sheet with proper angle frame-work along the top-border & bottom-below with four handle-shaped bars installed for lifting.

It is used to form specimen for concrete compressive strength testing. It can also be used as sample container in the determination of mortar set times.

Standardly manufactured from cast-iron having standard dimension of 150 x 150 x 150 mm & thickness 7.06cm with loose base plate. It comes under two categories, ISI-mark & Non-ISI-mark.

• Prime Mover : 1-phase or 3-phase 2 HP electric motor
• Vibrating Needle : Poker type (Available sizes 45mm, 50mm & 60mm of length 6mtr)